A CO2 laser turns a stack of balsa or light ply into a perfect rib set in minutes — every part identical, kit-quality, at home. Here's what it can and can't cut, how to size the bed to the planes you actually build, and four OMTech machines ranked for RC — from a $600 starter to a whole-wing shop machine.
Last reviewed: July 2026
It cuts flat parts, perfectly and repeatably: wing ribs, formers, fuselage sides, doublers, gussets, jigs — from balsa, light plywood, foam board, depron, and acrylic. Draw the part once and cut ten identical copies, or a whole rib set that actually lines up. It's how kit manufacturers make parts, and a desktop CO2 laser brings that home. If you build balsa or ply — or you want to sell short-run kits — it's transformational.
The single most important spec is bed size — it has to fit your biggest single part. A 20″-span rib fits almost anything; a full-size fuselage side or a 40″ wing panel needs a big table. Everything else is secondary:
Most desktop builders: the Polar Lite 55W. Its 20″×12″ pass-through bed swallows most ribs and formers, it cuts balsa and light ply in a pass, and it fits on a bench — the best balance of capability and space for RC. Just dabbling / tightest budget? The K40+ gets you cutting for a few hundred dollars if you accept the hands-on setup. Cutting whole wings or batching parts (or for others)? Step up to the 90W Maker for full rib sets, or the 100W Pronto for long one-piece fuselage sides. Buy for the biggest part you'll actually cut — bed size is the thing you can't upgrade later.
